Programmable Current Source (180mA to 900mA) Class-II (US) UL1310 compliant LED Driver, short circuit protected.

This Active Power Factor Corrected AC Powered LED Driver is a 30W, Class II (US UL-1310) isolated device with the following features:

• 100...277V AC - 50/60Hz
• Output programmable between 180mA and 900mA
• maximum LED drive capability 30 Watts
• Suitable for wet locations when fully potted
• Power factor > 0.92, typical 0.99
• Efficiency >87% over input voltage range
• THD <20% , typical 18%
• On / Off Touch Button functionality - 5 step DIMMABLE

The driver has 10 pre-programmed behaviors:

Programming:

Going from 0 to 1 back to 0 will toggle the active rest between 0% and 30% - the selection is indicated by the LED light output 0% = no light output and 30% = dim light output.

Program 1	Motion control input is enabled, when triggered, a period of 10 seconds fully on, 10 seconds warning (50%) going to 0% or 30% active rest. The dusk to dawn (DD) sensor input is considered and if high (daylight) the motion input is ignored and the light output is 0%.
Program 2	same as program 1 with motion enabled but a 1 minute interval, DD Sensor is considered.
Program 3	same as above but - 5 minute interval
Program 4	same as above but - 10 minute interval
Program 5	same as above but - 15 minute interval
Program 6	same as above but - 20 minute interval
Program 7	same as above but - 25 minute interval
Program 8	Motion disabled, DD disabled and 0-10V only
Program 9	Motion disabled, DD enabled and 0-10V if night detected.
Program 10	Motion and DD disabled - Touch Dimmer Only on Motion Input

Note: For touch dimmer applications (program 10) the sensitivity may have to be adjusted with an external resistor 50k..150kOhm between pin 1 and 2 of the motion input.

Chassis Ground may have to be connected to Signal Ground of the secondary side.

Order part numbers:

00-27-0725-0000	UL1598 listed enclosed with integral junction box
00-27-0725-0001	UL Recognized enclosed with 6" leads
05-17250011	UL recognized open frame

Technical Information

Supply Voltage	110..277V-AC (50/60 Hz)
Maximum Output Power	28W
Output Voltage	53V (no LED connected)
LED Voltage	9...45V-DC
Output Current	Adjustable Constant Current 60mA...900mA
Isolation	2500V
Channels	1

Caution! All specifications published herein are subject to change without notice. See website ActiveLED.com for Terms and Conditions of use of the website and the information provided herein. See Ringdale website on www.ringdale-technology.com for Terms and Condtions of Sale and Service.